Guard HTB

Guard HTB is a single pack, solvent-based, heat resistant, protective and decorative black coating for use at temperatures up to 600°C.

• Pack Size: 5 litres

• Colour: Black

• Gloss Level: Matt, Sheen

 

Recommended Uses

Guard HTB is a single component paint which is ideal for interior use onto suitably prepared steel and metal. Temperature resistant up to 600°C.

 

Application

• Brush: Yes. Small areas only

• Roller: Yes

• Conventional Spray: Yes. Thinner should not be required - maximum 5%

• Airless Spray: Yes. Not optimised

• Air Assisted Airless Spray: No

For further information and guidance on application, please refer to the Data Sheet or contact us.

 

Drying and Curing Time

• Touch Dry: 15-20 minutes

• Hard Dry: 4 hours

• Full Cure: Will occur after coating has been raised to a service temperature of at least 220°C for 20-30 minutes

• Re-coatable: Not recommended - small areas only

Drying times are based on temperatures of 20°C, lower temperatures will increase drying times. Please speak with our technical team before elevating temperatures or attempting to force cure any of our products unless already stated. Shop conditions such as having good airflow will optimise curing.

 

Compatibility

Should be applied directly to suitably prepared steel. Not suitable to be top coated.

 

Surface Preparation

• Ensure surfaces are clean, dry and free from grease and other contamination before coating.

• Thoroughly degrease and where applicable, abrade to remove rust and promote good adhesion of the coating. For optimum corrosion protection, mild steel should be blast cleaned to Sa2.5.

• Complex structures may be more effectively cleaned by HPWJ (high pressure water jetting).

 

Thinner

Guard Solvent A

 

Cleanup

Guard Solvent A

Once painting has been completed, clean all equipment with above mentioned cleaning solvent. Spray equipment should be appropriately flushed through for 3-5 minutes (returning unused paint to the tin, unless thinned which should be stored in a separate tin) before replacing any used solvent with clean solvent to leave in the pump, gun and lines.

 

Safety Precautions

To avoid the risk of spillage always store and transport in an upright secure position. Materials are hazardous and can also be flammable therefore appropriate precautionary measures must be taken including the use of gloves, glasses and recommended P.P.E in accordance with the material safety data sheets (MSDS).

Please refer to the product Data Sheet and Material Safety Data Sheets for full details regarding the safe use and storage of this product. We also offer free technical advice – click here to contact us.

 

Contact Us

For further advice regarding the use of this product, technical support or a quotation please contact us.