PPG SigmaCover 900

This product has now been discontinued. May we suggest using PPG Sigmacover 350 LT as an alternative.

PPG SigmaCover 900 is a two-component, solvent-free, amine-cured epoxy filler. Provides excellent adhesion to concrete and steel, with no shrinkage.

Product Benefits

• Excellent adhesion to concrete and steel
• Holes up to 3 cm (1.18 inch) can be filled in one application
• Can be used to smoothen a rough substrate
• Good insulating properties for dielectric shielding of impressent current anodes of cathodic protection system
• No shrinkage

Recommended Uses

• Steel
• Concrete

Substrate Conditions

• Steel: blast cleaned to ISO-Sa21⁄2, blasting profile 75 – 100 μm (3.0 – 4.0 mils)
• Concrete: cleaned from grease, dust and loose particles, preferably blast cleaned
• Moisture content of concrete should be maximum 4 %
• Previous coat: surface should be sufficiently roughened if necessary
• Previous suitable coat must be dry and free from any contamination

Substrate Temperature and Application Conditions

Application

• By means of a putty knife (avoid inclusion of air)
• Sandpapering possible after 24 hours

Cleaning Solvent

PPG Thinner 90-83 (preferred) or PPG Thinner 90-53

Colour and Finish

Colour: Grey (base: offwhite, hardener: black)

Finish: Gloss

Safety Precautions

• For paint and recommended thinners see Information Sheets 1430, 1431 and relevant Material Safety Data Sheets
• Although this is a solvent-free product, care should be taken to avoid inhalation as well as contact between the product and exposed skin or eyes

Contact Us

For further advice regarding the use of this product, technical support or a quotation please contact us.