Rust-Oleum EpoxyShield Concrete Repair Mortar

For levelling and repairing cracks, holes and other damages in interior and exterior concrete, cement renderings and unpainted brickwork.

• Pack Size: 10kg

--

 

Rust-Oleum EpoxyShield Concrete Repair Mortar

Rust-Oleum EpoxyShield Concrete Repair Mortar is a powdered repair product on cement base and resins for inside and outside use. For leveling and repairing cracks, holes and other damages in concrete, cement renderings and unpainted brickwork.

Pack Size: 10kg

 

Product Features

•  Traffic allowed after 24 hours

•  Recoatable after 48 hours

•  10 kg (1-component) – 0.4 m²

•  Sandable to a smooth finish

 

Surface Preparation

On bare substrate: clean with steel brush or sand blaster. The substrate must be solid and free from dust, oil and grease. Porous substrates must be moistened first. Metal parts are to be treated with an anti-rust primer (Combiprimer 3369/3380 or Hard Hat 2169/2182).

 

Application Conditions

Apply at a temperature of min. 5°C.

 

Application and Thinning

Rake/Trowel

 

Mixing & Thinning

Mixing ratio: Approximately 5 parts of powder to 1 part of water (2 litres of water for the entire 10 KG).

Fill the container with the water. Add the dry mortar to the water whilst stirring. Mix water and powder thoroughly to a thick smooth, lump-free substance. Add some water to your liking if the mortar is too dry.

 

Application

Apply the product with the included trowel or spatula up to a maximum layer thickness of 2 cm. Wet the trowel to smooth out any trowel marks or irregularities. After 48 hours the surface can be sanded using a rough sandpaper (P120) to obtain a smooth end result.

 

Cleanup

Clean tools and spillages with water.

 

Remarks

The mortar can now be over coated with EpoxyShield® coatings or other non-alkyd paints like Epoxies, Acrylics, etc.
If thicker layers are necessary (> 2 cm) the mortar can be mixed with kiln dried quartz sand. Mixing ratio: 1 volume part mortar plus 0,3 to 0,5 volume parts of kiln dried quartz sand (0 - 4 mm).

 

Contact Us

For further advice regarding the use of this product, technical support or a quotation please contact us.