Guard GIP Primer
Guard GIP Primer
Sale Sold out
Regular price From £28.21
(£33.85 Inc VAT)
Regular priceUnit price per
Guard GIP is a single pack high-build, solvent-based zinc phosphate primer, based on modified alkyd resin. Good anticorrosive properties under atmospheric conditions. Fast drying and fast handling. Pack Sizes: 5 litres, 20 litres Colours: Red Oxide, Grey, Black, White Gloss read more
Select Your Options
Guard GIP is a single pack high-build, solvent-based zinc phosphate primer, based on modified alkyd resin. Good anticorrosive properties under atmospheric conditions. Fast drying and fast handling.
- Pack Sizes: 5 litres, 20 litres
- Colours: Red Oxide, Grey, Black, White
- Gloss Level: Matt
Guard GIP is principally intended for prepared mild steel substrates, ferrous and suitably prepared non-ferrous metal substrates. High build zinc phos primer
- Brush: Yes - Small areas only, or for strip coating - Thin 0.2% with Guard Solvent F
- Roller: Yes - Small areas only - Thin 0.2% with Guard Solvent F
- Conventional Spray: Yes - Thin 5-10% - added as approx 3-5% each time, 1.8-2.0mm nozzle orifice, 0.4 Mpa nozzle pressure
- Airless Spray: Yes - 0-5% Thinner - 0.38-0.48 nozzle orifice, 12.0-16.0 Mpa nozzle pressure
Air Assisted Airless Spray: Yes - 0-5% Thinner - 0.38-0.48 nozzle orifice, 12.0-16.0
Mpa nozzle pressure
For further information and guidance on application, please contact us.
Drying and Curing Time
- Touch Dry: 15 minutes
- Hard Dry: 12 hours
- Full Cure: 24 hours
- Re-coatable: 45 minutes minimum
Drying times are based on temperatures of 20°C, lower temperatures will increase drying times. Please speak with our technical team before elevating temperatures or attempting to force cure any of our products unless already stated. Shop conditions such as having good airflow will optimise curing.
Recoatable with most one and two-component coatings including Guard FEB and Guard FES (alkyds) or Guard SPU (polyurethane) single pack topcoats or Guard MSP-2K for extra durability.
Thoroughly degrease and where applicable, abrade to remove rust and promote good adhesion of the coating. For optimum corrosion protection, mild steel should be blast cleaned to Sa2.5 or power tooled to achieve ST3. Complex structures may be more effectively cleaned by HPWJ (high pressure water jetting).
Substrate temperature during application and curing should be above 5°C (41°F). Substrate temperature during application and curing should be at least 3°C (5°F) above dew point.
Guard Solvent A
Guard Solvent F (for brush/roller)
Guard Solvent A
To avoid the risk of spillage always store and transport in an upright secure position. Materials are hazardous and can also be flammable therefore appropriate precautionary measures must be taken including the use of gloves, glasses and recommended P.P.E in accordance with the material safety data sheets (MSDS).
Please refer to the product Data Sheet and Material Safety Data Sheets for full details regarding the safe use of this product. We also offer free technical advice – click here to contact us.
For further advice regarding the use of this product, technical support or a quotation please contact us.