Select Your Colour
- DESCRIPTION
- Datasheet
DESCRIPTION
Two-pack high performance floor coating providing a hygienic, easy-clean and hard-wearing resin floor system.
- Pack Sizes: 5kg and 15kg
--
RSL Resuflor HB - formerly Resucoat HB
RSL Resuflor HB is a two-pack high performance floor coating providing a hygienic, easy-clean and hard-wearing resin floor system.
Pack Sizes: 5kg and 15kg
Product Description
Incorporating technology based on high solids epoxy resin technology which is designed to provide a tough and durable floor protection finish in a variety of thicknesses and colours for a wide range of applications, Resuflor HB will provide a smooth gloss finish to which anti-slip aggregate can be added if required.
Product Benefits
- Single coat application up to 500 microns
- Wide range of colours available
- Seamless
- Hygienic
- Easy to clean
- Chemical resistance
Yield
5 kg will cover 17m2 @ 200 microns wet film thickness.
*Coverage rate is calculated based on a sealed and smooth surface and may vary based on the substrate roughness and other conditions.
Colour
Available in a wide range of colours.
Product Advantages
- High-build finish
- High solids
- Hygienic and easily cleaned
- Good colour stability
- Excellent slip resistance with the inclusion of selected aggregates
- Excellent high gloss finish
Recommended Uses
- Food processing and beverage areas
- Chemical plant rooms
- Engineering workshops
- Automotive & aviation areas
- Factory unit floors
- Warehouses
- Excellent for all demarcation and walkway areas
Product Application
Resuflor HB is easy to apply by roller and paint brush to create a seamless, hard wearing and hygienic floor finish.
The ambient temperatures of the areas should not be allowed to fall below 15°C throughout the application and the curing period, as this could have an adverse effect on the appearance and colour of the system. Surface temperature must be above 10°C. Where possible it is recommended that the application area is heated to a minimum temperature of 15°C ideally to allow the ambient and substrate temperature to stabilise prior to installation.
Mixing
Pre-mix the coloured base component to a uniform consistency then mix the entire contents of the base with the hardener. If a separate mixing bucket is being used mix thoroughly ensuring all contents of both components are removed from the buckets supplied. Mix using a slow speed electric mixer for approximately two to three minutes until the two components have fully combined. The mixed unit should be applied immediately by roller or brush with a consistent procedure. Floor areas should be cross-rolled to ensure even application and to minimise roller marks
Contact Us
For further advice regarding the use of this product, technical support or a quotation please contact us.
Datasheet

×