Fosroc Nitomortar PE Concrete Std

Technical Information

Nitomortar PE products are based on a polyester resin system. There are two grades. Nitomortar PE: The standard material for general purpose use. Nitomortar PE Concrete: A special grade allowing users to add suitable aggregate, thereby substantially reducing the cost of infilling larger voids. A winter version of Nitomortar PE Standard is available which is faster setting at low ambient temperatures. Both grades of Nitomortar PE are supplied as two-component products with pre-weighed quantities of liquid resin and powdered hardener, ready for on-site mixing and use. The hardener system enables the mix to be varied from a pourable consistency to a trowellable mortar without significantly affecting the setting times or strengths achieved.

Where To Use

For fast and emergency reinstatement of concrete, bedding, jointing and reprofiling of concrete, masonry and brickwork. Nitomortar PE is ideally suited for the repair and reprofiling of precast concrete units, damaged arrises and treads. It can be used to infill hollows and holes in concrete floors, bedding and fixing kerbstones, manhole sets, frames, brick slips, ceramic tiles, slabs and coping stones. Nitomortar PE Concrete should be used to repair larger voids. The products are especially useful where fast strength gain is important. When properly compacted, they are highly impermeable.

Advantages

•  Fast development of strength minimises disruption — stronger than concrete within 2 hours
•  No primer required
•  High chemical and oil resistance
•  Extremely versatile — can be poured, trowelled or modified with aggregate without significantly affecting setting times or strengths
•  Extremely low wastage due to ability to mix part packs to consistencies required
•  Will cure down to 0°C
•  Pre-weighed components ensure consistency