Fosroc Paveroc

Technical Information

Paveroc is designed for horizontal use. It may be applied up to a maximum thickness of 100 mm. Thicker sections can be built up in layers. Material should not be applied at less than 12 mm thickness. Individual bay sizes should not exceed 18 m². Consult the local Fosroc office for further information. Paveroc is supplied as a ready to use blend of dry powders which requires only the site addition of clean water to produce a highly consistent repair mortar. It is based on Portland cements, graded aggregates, and chemical additives providing a mortar with good handling characteristics while minimising water demand. The low water requirement ensures good strength gain and long-term durability. The product is alkaline in nature and will protect embedded steel reinforcement.

Where To Use

For the reinstatement or resurfacing of large areas of concrete pavements, ramps and floors to avoid the full depth replacement of bays. It may be used internally and externally including areas subject to heavy trafficking Paveroc can be used in conjunction with Fosroc Hardtop S for the repair of floors with a dry shake floor surfacing Paveroc is suitable for repair methods 3.1, 3.2, 4.4, 7.1, 7.2 as defined by BS EN 1504-3.

Advantages

•  Long open time - applicable to large bay areas
•  High strength, abrasion and weather resistance
•  One component, pre-bagged to overcome site-batched variations requires only the site addition of clean water
•  Excellent bond to the concrete substrate
•  Shrinkage compensated
•  Contains no chloride admixtures