Amercoat 385 (SigmaCover 385)

This product is now discontinued, a potential alternative coating would be; Sigmacover 456

Description

Amercoat 385 also known as Sigmacover 385 is a two component high build epoxy coating.

Product Features and Benefits

• Multi-purpose high build epoxy
• High solids high build epoxy intermediate coat
• Compatibility with a wide range of substrates and surface preparations
• Excellent resistance against chemical spillage
• Amercoat 385 PA contains zinc phosphate for enhanced corrosion inhibitive performance, which is available in US and Asia Pacific only
• Also available with MIO pigmentation
• Amercoat 385 LH is formulated for a lower level of HAPs, which is available only in US

Recommended Uses

• Mild steel
• Galvanised steel
• Stainless Steel
• Non-ferrous metals
• Concrete

Please refer to the Data Sheet for usage instructions.

Substrate Temperature and Application Conditions

• Coating performance is, in general, proportional to the degree of surface preparation
• Abrasive blasting is usually the most effective and economical method. When this is impossible or impractical, coating can be applied over mechanically cleaned surfaces
• All surfaces must be clean, dry and free of all contaminants, including salt deposits. Contact PPG for maximum allowable salt containment levels
• Surface temperature during application should be at least 3?C (5?F) above dew point
• Ambient temperature during application and curing should be between 4?C (40?F) and 50?C (122?F)
• Relative humidity during application should not exceed 85%

Colours

Contact Us

For further advice regarding the use of this product, technical support or a quotation please contact us.