RD-Cement Mix

Water based emulsion based on synthetic resins to be used together with RD-Cement Filler for additional flexibility.

USE:

RD-CEMENT MIX is a water based emulsion based on synthetic resins.

FEATURES:

RD-Cement MIX:

• Has very good mechanical and elastic properties
• Tensile strength: 6 N/mm2
• Elongation at break: 1000%
• Temperature Resistance: -30 ? C – + 70 ? C
• Surface tension: 30 mN / m.?APPLICATION CONDITIONS:
  

  APPLICATION CONDITIONS:

  Can be used with any hydraulic binder
  -Unsaponifiable material;
  - Environmentally friendly;
  - Can be used as a primer or as an adhesion primer for cement grouts or plaster work on difficult to treat smooth surfaces such as concrete, smooth tiles, paint, glass, plastic and so one;
  - As an insulating primer on any type of burnt areas, water spots, etc. which have to be filled, painted or plastered afterwards.

  This should be done like this: make a dilution of 1 part of water and 1 part of RD-Cement Mix.
  Apply until the surface feels sticky (not dry) and after this, apply the plaster immediately.

  APPLICATION MEANS:

  Flat brush or normal brush.

  PARTICULARITIES:

  RD-CEMENT FILLER mixed with RD-CEMENT MIX 20% shows an excellent brushability to make the walls of concrete tanks, water purification stations, collection tanks, concrete water channels etc. waterproof.

  Procedure:

  1. Substrate Preparation: As substrate, any type of porous concrete or masonry is suitable. Bad joints, cavities and damage must be filled first by means of RD-CEMENT FILLER (see technical data sheet) Metal which should be coated, pre-treat with RD-ELASTOMETAL.
  2. The substrate should be supporting, clean, stripped of loose parts and may be dry or slightly humid, max. 5%. Remove hydrophobic rests such as oils, grease or ancient coats.
  3. Finish:

   

• Apply 1 coat of RD-CEMENT MIX diluted with 1 part water, so 1 on 1, on the concrete ? Consumption: about 4 m?/L, depending on the porosity of the substrate.
  

• Apply 2 coats of mixed RD-CEMENT FILLER with RD-CEMENT MIX by means of a flat or normal brush. Application of the second coat should be done after drying of the first one. Consumption: at least 2 kg of mixed product m?.
  In order to change the brushability, water may be added. Do not apply during bad weather conditions, abundant rain and risk of frost.

  DRYING TIME (20C – 68F):

  Touch dry: +/- 1h hour
  Recoatable: +/- 4 hours

  CLEANING OF TOOLS:

  Water

  FINISH(Gardner 60?):

  The primer penetrates in the substrate and gives a glossy aspect.

  COLOURS:

  Colourless.

  DENSITY:

  1.01 +/- 0.05 g/cm?

  SOLIDS CONTENT:

  In weight: 48,5 % +/-2
  In volume: 48,5 % +/-2

  VISCOSITY:

  30 m Pas (ISO3219)

  VOC CONTENT:

  0 g/L

  FLASH POINT:

  Not flammable

  STORAGE:

  24 months, keep away from frost and store away from heat.