Rust-Oleum 5180 Epoxy Repair Mortar

A very strong, non-shrink epoxy mortar for repairing damaged interior and exterior concrete floors and steps.

• Pack Sizes: 2.5kg, 5kg and 25kg

--

 

Rust-Oleum 5180 Epoxy Repair Mortar

Rust-Oleum 5180 Epoxy Repair Mortar is a very strong, non-shrink epoxy mortar for repairing damaged interior and exterior concrete floors and steps.

Pack Size: 2.5kg, 5kg and 25kg

 

Product Benefits

• Stands up to heavy traffic and many chemicals

• Does not shrink or crack

• For repairing eroded or damaged concrete, bay edges and broken steps

• Easy all-in-1 packaging

• For interior and exterior use

• Can be recoated quickly

 

Recommended Use

For repair of damaged, dished or dangerous concrete or stone floors or stairs. Provides a permanent repair to badly cracked and worn concrete and stone floors - will fill holes of any shape or size, gaps, nosings, cracks etc - may be feather edged.

 

Surface Preparation

Concrete and stone surfaces should be dry and free from previous coatings, contaminants and loose material and at least four weeks old. Very smooth concrete or concrete with soft laitance should be etched with Surfa-Etch 108. Grease or oil should be removed with ND14 Cleaner/Degreaser and the area thoroughly washed off and allowed to become completely dry.

It is recommended to prime the area to be repaired with 5401 Impregnation Primer before applying repair mortar. Allow the 5401 to flash off for approximately 30 – 60 minutes before applying 5180 repair mortar.

 

Directions for Use

The pack contains a granular resinous material and one or more bottles (depending on the packaging size) of curing agent. Mix the granular resinous material with the curing agent on a board. It is important that mixing should be carried out very thoroughly. The ratio of resin to curing agent is critical and the mixing of part packs is not recommended.

 

Application Conditions

Temperature of material, air and substrate between 10°C - 35°C and relative humidity below 85%. The substrate temperature must be at least 3°C above dew point.

 

Application and Thinning

Rake/Trowel

Trowel vigorously over the prepared surface. Final levelling should be carried out with a steel float. To prevent ‘drag’ it is advisable to wipe the blade of the tool frequently with a rag moistened (but not saturated) with white spirit. The working life of the mixed product is half to one hour depending on temperature. If the product is used past its working life, trowelling will become difficult and adhesion reduced.

 

Cleanup

Clean equipment and spills using Rust-Oleum Thinner 160.

 

Remarks

Product can be applied from feather-edge to 50 mm depth (full strength is achieved at 5 mm). Build up layers of Rust-Oleum 5180 if the depth is significantly greater than 50 mm or use Rust-Oleum 5190 Deep Fill Repair Mortar. Applying the product directly in a too high film thickness can reduce the performance of the cured material.

Curing time will be extended by low temperatures. Temperatures of 10°C and below will arrest the curing of the product. When fully cured, detergents and degreasers may be used to clean the surface. Do not steam clean or subject to temperatures in excess of 60 °C.

 

Contact Us

For further advice regarding the use of this product, technical support or a quotation please contact us.