Nufins Epigard Waterproof Membrane

A two component extended epoxy high build coating characterised by its inbuilt flexibility, excellent adhesion and resistance to water and a wide range of chemicals. 

• Available in a 5kg unit.

--

PRODUCT DESCRIPTION;

A two component extended epoxy high build coating characterised by its inbuilt flexibility, excellent adhesion and resistance to water and a wide range of chemicals.

Epigard will successfully protect concrete structures including abutments, wing walls and bearing shelves, drainage channels, silos and tanks.

PACK SIZE;

5kg

YIELD;

4-6m2 /kg

PRODUCT ADVANTAGES;

No primer required
excellent bond strength
Good chemical and abrasion resistance
Inbuilt flexibility

PRODUCT APPLICATIONS;

A chemically resistant, waterproof protective coating for concrete and steel structures.

SURFACE PREPARATION;

All surfaces should be clean, dry, free from oil, grease and chemical contamination. Oil and grease can be removed using Desolve. Concrete surfaces should be free from laitance, this should be removed by either scarifying, wire brushing or preferably by high pressure water or sand blasting. Blow holes or other surface irregularities should be repaired using Nupatch Cosmetic or Epolite. Concrete surfaces should be at least 21 days old. Mixing Mix only full units. The entire contents of the hardener should be added to the base and mixed thoroughly, avoiding incorporation of air. Care should be taken to prevent unmixed material remaining in the mixing vessel.

APPLICATION INSTRUCTIONS;

Epigard may be applied by brush, roller or airless spray. The first coat may be tinned with up to 10% Nuwash to aid application. Two coats are normally applied.
All equipment should be cleaned with Nuwash immediately after use.

IMPORTANT; Do not apply at temperatures below 7°C.