Sherwin Williams Resuflor HB

Resuflor HB (formerly known as Resucoat HB) is a two-pack, high performance floor coating, providing a hygienic, easy-clean and hard-wearing resin floor system.

• Pack Sizes: 5kg and 25kg 
  
  

Sherwin Williams Resuflor HB - formerly Resucoat HB

Pack Sizes:

5kg and 25kg

Product Description;

Incorporating technology based on high solids epoxy resin technology which is designed to provide a tough and durable floor protection finish in a variety of thicknesses and colours for a wide range of applications, Resuflor HB will provide a smooth gloss finish to which anti-slip aggregate can be added if required.

Product Benefits;

• Single coat application up to 500 microns
• Wide range of colours available
• Seamless
• Hygienic
• Easy to clean
• Chemical resistance 
  
  

Yield;

5 kg will cover *17m2 @ 200 microns wet film thickness.

*Coverage rate is calculated based on a sealed and smooth surface and may vary based on the substrate roughness and other conditions.

Standard colours;

RAL 7035, RAL 7038, RAL 7040, RAL 7042, RAL 7043, RAL 6002, RAL 5017,

RAL 1032, RAL 3020, RAL 3011, RAL 9011, RAL 9003

Also available in a wide range of non-standard colours by clicking here

Product Advantages;

• High-build finish
• High solids
  
• Hygienic and easily cleaned
  
• Good colour stability
• Excellent slip resistance with the inclusion of selected aggregates
• Excellent high gloss finish

Recommended areas of use;

• Food processing and beverage areas
• Chemical plant rooms
• Engineering workshops
• Automotive and aviation areas
• Factory unit floors
• Warehouses
• Excellent for all demarcation and walkway areas

Product Application;

Resuflor HB is easy to apply by roller and paint brush to create a seamless, hard wearing and hygienic floor finish.

The ambient temperatures of the areas should not be allowed to fall below 15°C throughout the application and the curing period, as this could have an adverse effect on the appearance and colour of the system. Surface temperature must be above 10°C. Where possible it is recommended that the application area is heated to a minimum temperature of 15°C ideally to allow the ambient and substrate temperature to stabilise prior to installation.

 Mixing;

Pre-mix the coloured base component to a uniform consistency then mix the entire contents of the base with the hardener. If a separate mixing bucket is being used mix thoroughly ensuring all contents of both components are removed from the buckets supplied. Mix using a slow speed electric mixer for approximately two to three minutes until the two components have fully combined. The mixed unit should be applied immediately by roller or brush with a consistent procedure. Floor areas should be cross-rolled to ensure even application and to minimise roller marks

Contact Us;

For further advice regarding the use of this product, technical support or a quotation please contact us.