- DESCRIPTION
- Datasheet
DESCRIPTION
International Interzone 101 is a two component, solvent free epoxy which can be applied underwater and will cure underwater to give a corrosion and abrasion resistant coating.
- Pack size: 12 litre unit
- Colours: Green
Recommended Uses
As a hand-applied repair compound for application to submerged steelwork and splashzone areas of offshore jackets, piling and other permanently wet areas where conventional coatings can not be used.
Interzone 101 can also be used on glass reinforced materials and concrete and is suitable for use at new construction as well as maintenance.
Surface Preparation
The performance of International Interzone 101 will depend upon the degree of surface preparation. The surface to be coated must be clean and free from contamination. Prior to paint application all surfaces should be assessed and treated in accordance with ISO 8504:2000.
Accumulated dirt and soluble salts must be removed. Dry bristle brushing will normally be adequate for accumulated dirt. Soluble salts should be removed by fresh water washing.
Oil or grease should be removed in accordance with SSPC-SP1 solvent cleaning.
Method of Application
- Hand Moulding
- Knife
- Squeegee
- Trowel
Please refer to the Data Sheet for additional preparation, application and safety instructions prior to usage.
Systems Compatibility
In most circumstances this product is applied direct to steel and is not overcoated. Where a blast holding primer may be required then Interline 982 epoxy holding primer should be used and must be overcoated within a maximum of 10 days.
Thinner
DO NOT THIN. Interzone 101 should not be thinned under any circumstances.
Clean Up
Thoroughly flush all equipment with International Thinner GTA822. Once units of paint have been mixed, they should not be resealed.
Clean all equipment immediately after use with International Thinner GTA822. It is good working practice to periodically clean equipment during the course of the working day. Frequency of cleaning will depend upon amount used, temperature and elapsed time, including any delays.
All surplus materials and empty containers should be disposed of in accordance with appropriate regional regulations/legislation.
Safety Precautions
This product is intended for use only by professional applicators in industrial situations in accordance with the advice given on the Data Sheet, the Material Safety Data Sheet and the container(s), and should not be used without reference to the Material Safety Data Sheet (MSDS).
All work involving the application and use of this product should be performed in compliance with all relevant national, Health, Safety and Environmental standards and regulations.
In the event welding or flame cutting is performed on metal coated with this product, dust and fumes will be emitted which will require the use of appropriate personal protective equipment and adequate local exhaust ventilation.
Contact Us
For further advice regarding the use of this product, technical support or a quotation please contact us.